| |
|
| |
|
 |
 |
| |
|
- Heavy duty bearings
- High efficiency copper wound motor
- In-built lip seal to prevent ingress of silt and sand
- Float switch is provided upto 0.75 kw - 1ph
- Sewage pump Can handle solids upto 15mm & dewatering pump Can handle solids up to 30 to 60mm
- The relatively small size and weight make these pumps specially suitable for temporary services like dewatering of construction sites and for emergency services in case of flooding.
- The pumps at equipped with a handle which makes it easy to move them from one point of application to the other.
- Pumps are designed for free standing installation, but can also be permanently installed by means of an auto coupling guide rail system
- Pumps in permanent installations can cope with PH-values ranging from 4 to 10.
- Permissible Liquid temperature: 0° to 40°C
- All pumps are supplied with 15 meters cable up 3 HP pumps & 20 meters cable upto 5 to 10 HP pumps
- The stator windings incorporate temperature sensors (PTC Or TOP) which cut out the motor in case of over temperature. (Temperature sensors (PTC OR TOP) are built into the stator windings, and a contact in the sensors will open on case of over temperature i.e. 120 oc.)
|
| |
|
| Power Range |
0.37 – 2.2kW (1 Phase) & 0.37 – 7.5kW(3 Phase) |
| Speed |
2900 RPM |
| Degree of protection |
IP 68 |
| Motor type |
Dry |
| Impeller type |
Semi-open, non-clog |
| Insulation type |
Class F |
| Version |
Single Phase: 230V, 50Hz, A.C. Supply. Three Phase: 380 - 415V, 50/60Hz, A. C. Supply |
| Direction of rotation |
Clock wise (when viewed from driving end) |
| Duty |
S1 Continuous |
|
| |
|
| Part Name |
Material |
| Pump casing |
Cast Iron |
| Motor frame |
S.S. 304 |
| Impeller |
Cast Iron / Polyamide |
| Shaft |
S.S. 420 |
| Mechanical seal |
Dual Mechanical Seal Silicon Carbide and Carbon Ceramic |
|
| |
|
| |
|
|
|
|
|
|
